Human silicone rubber

Human silicone with good softness is generally very good when it is between 0-10 degrees, and the softness can even reach 0 degrees or below.

For mask manufacturers, using 5 degrees, 10 degrees, and 15 degrees is more common, compared to using 0 degrees for doll manufacturers. There are more types of skin products that use 0 or 5 degrees.

Usage: Mix components A and B evenly in a 1:1 ratio by weight, and then pour them after vacuum defoaming. 30 minutes of operation at room temperature (25 degrees Celsius), 3-4 hours of complete curing; Under the premise of a vacuum machine, it can be considered to heat up 60-120 degrees, which can completely solidify in a few minutes;

Attention: Liquid human silicone should be stored in a sealed manner, and the mixed human silicone should be used up at once within the specified time to avoid waste caused by the curing of the adhesive material· Avoid contact between rubber materials and materials containing nitrogen (N), phosphorus (P), sulfur (S), tin (Sn), lead (Pb), mercury (Hg), alcohols, water, etc., such as organic tin compounds and silicone rubber containing organic tin sulfur, sulfides, sulfur containing rubber, ammonia compounds, and materials containing ammonia. Also, do not contact containers or molds that have been adjusted with condensation type adhesives. Otherwise, surface adhesion may occur when adding liquid silicone rubber Phenomena such as incomplete or even incomplete curing· When operating, it is necessary to distinguish it from containers that have used condensed silicone. Use unused room temperature silicone tools to operate this silicone to avoid non curing or surface sticking, incomplete curing signs, or even non curing. At the same time, avoid contact with oil sludge, various types of clay, raw ash, and solder.