Dripping process operation of silicone buttons

Let Ruibo Rubber Products Co., Ltd. tell you about the dripping process of silicone buttons!

1、 Mix the epoxy resin and curing agent in a certain proportion, and then put them into a drip can after mixing

2、 Use a dropper to pour an appropriate amount of epoxy resin into the surface of the silicone buttons used for screen printing, laser carving, and oil spraying, and let it flow evenly to the surface of the silicone buttons;

3、 If the area of adhesive dripping is relatively large or the amount of adhesive dripping is relatively large, it may cause the product to produce adhesive bubbles. In this case, a flame gun or a flame spray must be used to help eliminate bubbles;

4、 Usually, after placing the silicone button for 12 hours, the epoxy resin on its surface will also solidify;

5、 After waiting for the epoxy resin to cure, the dripping process will be officially completed.