How to minimize the distortion of O-ring?

When the sealing ring O-ring is properly assembled and the service conditions are appropriate, it will not roll or twist under the reciprocating motion state, because the contact area between the rubber O-ring and the groove is larger than the friction contact area on the sliding surface, and the resistance of the rubber O-ring itself can prevent the distortion. However, in improper use, it is easy to cause distortion, resulting in damage and leakage. How to minimize the distortion of O-ring?

Reasons for distortion of sealing ring O-ring

1. The clearance between piston, piston rod and cylinder barrel is uneven;

2. The section diameter of O-ring is uneven;

3. The friction force on the O-ring is uneven.

Methods to prevent the O-ring from being twisted and damaged:

1. The section size of rubber O-ring shall be uniform, and the sealing part shall be fully coated with lubricating oil or grease during each installation.

2. Increase the section diameter of the rubber O-ring. The section diameter of the O-ring for dynamic sealing should generally be larger than that of the rubber O-ring for static sealing. In addition, the rubber O-ring should not be used as a seal for large-diameter pistons.

3. The concentricity of the installation groove of rubber O-ring should be considered from two aspects: convenient processing and no distortion.

4. When distortion damage occurs under low pressure, seal ring can be used to protect the retaining ring.

5. The rubber O-ring can be replaced by a sealing ring that is not prone to distortion.

6. The O-ring is made of materials with low friction coefficient.

7. Reduce the surface roughness of cylinder barrel and piston rod.